C-Bus 5200PG Specifiche Scaricare il pdf (Pagina 16)

Wiser Home Controller Installation Instructions

3.4 Step 1, Connect the CNI to the C-Bus Network Cable

The C-Bus network and the Ethernet LAN are electrically isolated inside the

CNI unit. The C-Bus network provides power for the C-Bus side of the CNI

circuit board.

Do not connect the C-Bus side of the CNI to an Ethernet LAN. Damage to

the equipment will occur.

1. Open the cable access door on the CNI unit.

2. Crimp the wire pairs using bootlace connectors. Connect the

twisted pairs for C-Bus positive (+) and C-Bus negative (-) to the

screw terminals on the PCB connector. The C-Bus network cable

wire colour assignments are defined in Figure 7.

Note: You can install a second set of twisted pairs to daisy chain to

another C-Bus device. For best results, use bootlace crimp connectors.

3. Install the plastic strain relief piece. The strain relief is in the shape

of the letter 'H.'

4. Close the access door. The CNI is now ready for attachment to the

router and busbar.

C-Bus Connection Colour

C-Bus Positive (+) blue

C-Bus Negative (–) blue & white

C-Bus Positive (+) orange

C-Bus Negative (–) orange & white

Figure 7. C-Bus cable details for the C-Bus network

Note

: Wireless C-Bus devices require a C-Bus Wireless Gateway unit. They do not

communicate directly with the Wiser Home Controller's wireless LAN.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 49 50

Nessun commento

C-Bus 5200PG Specifiche Pagina 16