C-Bus 5200PG Specifiche Scaricare il pdf (Pagina 7)

Wiser Home Controller Installation Instructions

1.2 Software

Normally, the installer loads PICED and C-Bus Toolkit on a PC and brings it

to the customer site.

Software Applications

When installing the Wiser Home Controller, you must use the downloaded

versions of the following Clipsal software applications:

• PICED setup software, version 4.5, or later. Access the PICED

software using the link in the

readme.htm file located on the

provided Wiser USB drive.

• C-Bus Toolkit setup software, version 1.10.2, or later. The latest

C-Bus Toolkit version is available at the Clipsal Integrated Systems

technical downloads site:

http://www2.clipsal.com/cis/technical/ select Downloads.

You must use the latest PICED software to obtain the latest firmware and

the automatic firmware update feature. If you are unsure about the

correct software versions to use, contact Technical Support.

The PICED setup software contains the latest Wiser Home Controller

firmware .IMG file. The latest firmware is loaded automatically as part of

transferring your PICED project to the Wiser Home Controller. The setup

packages also include the latest CNI configuration software, C-Gate and

transfer utilities. Refer to Section 4.3.

Graphical User Interface (GUI)

After configuring the Wiser Home Controller, your entry point to the Wiser

Home Controller is the Wiser Graphical User Interface (GUI). Refer to

Section 5.0 for more information about using the GUI. The factory installs

the GUI and a sample project in the Wiser Home Controller router. The

sample project is not intended to be used as is; you must create a new

project with PICED.

To access the GUI, connect to the LAN and open a browser session. Clipsal

recommends using Internet Explorer or Mozilla Firefox. Type the following

IP address and press Enter:

http://192.168.2.1

The username is admin and the password is admin

1 2 3 4 5 6 7 8 9 10 11 12 ... 49 50

Nessun commento

C-Bus 5200PG Specifiche Pagina 7