C-Bus 5200PG Specifiche Scaricare il pdf (Pagina 39)

Wiser Home Controller Installation Instructions

Projector Control Enable allows the web user interface to function even

when run remotely over the Internet. This feature is intended to allow an

end-user or installer to interact with their C-Bus network even when outside

of their home or premise.

Project Update Enable allows a PICED project to be uploaded to the device

over the Internet. This means that anyone on the Internet, if they knew the

Internet address of your device, can connect to the device and transfer a

project to the unit and/or retrieve a project from the unit. It is important to

make sure to close the port after usage as leaving it open will allow anyone

to manipulate your C-Bus network.

Q8: Can I transfer a PICED project from the router to my PC using the

project that I previously loaded on to a router?

A8: Yes, you can transfer a project from the PC to the Wiser Home

Controller and transfer a loaded program back to the PC.

Q9: How do I set up Port Forwarding on my Wiser Home Controller?

A9: The screen below is a representation of how your modem /router

(Not the Wiser unit) should be configured to support access to the Wiser

Home Controller from the Internet.

Note: This setup is only applicable if you are connecting the Wiser Home Controller

behind your Modem/Router. It does not apply if you are using you’re a bridged

Modem or have configured your modem/router to work as a bridged modem.

Q10: How do I use the port definitions built into the Wiser Home

Controller?

A10: To use the Port Definitions refer to the table and the notes that

follow: See Note 1 Wiser Home Controller Wan IP

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 49 50

Nessun commento

C-Bus 5200PG Specifiche Pagina 39